Connect to your UDrive and PASS Space from Windows Computers

Wait!  Did you try WebFiles?  A lot easier if you just need to grab a file or two.

Download

32 bit version (2.1.0) - MapPSUSpace-x86.msi
64 bit version (2.1.0)
 - MapPSUSpace-x64.msi

Previous version can be downloaded here

Installation

Just run the MapPSUSpace installer and restart, it takes care of the rest. You will need to restart your computer after installing to complete the installation.

Note: your computer's clock must be set to the correct time (within a half minute or so) for authentication to work with Penn State's system.

Connecting to your UDrive and PASS Space

You will need to connect to the Penn State VPN before you can connect to your UDrive and PASS space. If you're already connected to Wireless 1.0 on campus then you won't need to do any other steps with the VPN client. Otherwise, connect to the "ISP to PSU" network from the network list in the VPN client.

After connecting to the VPN, run the MapPSUSpace program. Type in your Access Account username and password and hit Connect to connect the drives. You can also choose to connect to only your PASS Space or UDrive. You can also connect to UBackup if needed.

Screen shot of Map PSU Space program

You can now access your UDrive and PASS Space just like any other hard drive! Open up your Computer and then open up the drive you want to access.

If you have problems, search the ITS Knowledge Base for possible solutions.

Requirements

.NET 4.5 must be installed.
Windows 7 or above is required, has been tested on Windows 7, 8.1 and Windows 10.
Administrive privileges are required for initial install.

Changelog

2.1.0 (2016-05-03)

  • Added support for Windows 7,8 and Windows 10, 32 bit and 64 bit versions
  • Rewritten in .NET for better support and reliability
  • Improved authentication with dce.psu.edu realm, resolving common issues with authentication
Content Tagging: 

Last Updated May 3, 2016